The Model TC241 is a low cost curing system designed for a variety of products which include: Silver Paste, Conductive and Legend Inks, LPI and Peelable Solder Masks.

OPERATIONS PARAMETER DISPLAY
Adjustments for the conveyor speed, power settings of cure zone. The control panel will display the actual speed of the conveyor, power settings and the actual temperature of the PCB being cured.

CONVEYOR
Constructed of 304 stainless steel.The conveyor is driven by DC motor and is adjustable to run between 0 to 6 FPM.

INFRARED QUARTZ LAMP
This is the heart of the system. The type of lamps used in this system are very efficient. Warm up time of the system is less the 30 minutes! The lamps are operated and adjusted via SCR controllers.

LAMP HOUSING
Constructed with stainless steel, easy access of housings, both the top and bottom housing can be easily accessed without the need to disassembe the machine. The top and bottom housings are mounted on a track system and can be pulled out for easy access to the top and bottom lamps. If panels need to be taken out of machine, all electrical is mounted with quick disconnects and there are only 4 mounting bolts per panel.

IR THERMOMETER
There is a IR thermometer located at the exit of each cure zone. These thermometers read the actual temperature of the PCB being cured. The IR sensors are protected by an air purge cooling system.

COOL-DOWN ZONE
The cool-down zone utilizes forced air panels located above and below the conveyor.

SAFETY INTERLOCKS ON SERVICE DOORS
Ensure the safety of the operator during operation. If any of the service doors are opened during operation the lamps and conveyor will be disengaged.
WARRANTY: 6 month parts, FOB ACS factory.

Model TC241

• Conveyor Width: 25" working
• Conveyor Working Height: 36" adjustable
• Conveyor Drive Assembly: AC Motor Driven
• Power Requirements: 208-240 VAC, 3 Ph, 60Hz
• Power consumption: 50 amps, 21 kw @ 100% output
• Required Exhaust: 800 CFM, 8" Duct
• Construction: 304 Stainless steel
• Control: Analog
• Heating: High Density Infrared Quartz Lamps
• Dimensions: 71”/1803mm L x 38”/965mm W x 57”/1448mm H
  Specifications are subject to change without prior notice

   

Click here to email a link to this page

Click here for printable .pdf brochure